A)  The bearings were seized due to two factors:

• Sealing arrangement(non existent)
• Pipe that keeps the bearing inline bends, thus all alignment goes astray.

B) The axle with a 48mm wheel bore diameter and 50 diameter axles the load impact factor is to low.

C) The clamping arrangement causes misalignment.

THE SOLUTION TO THIS IS THE QUATRO:

1. The pipe was taken away and double bearings were fitted with seals  in a decent housing with a new design.

FROM C/BOX TO QUATRO

2.The axle diameter increased from 50mm to 75mm, this now will increase the load/impact resistant.

3. The misalignment of the cannon box consisting of a clamp. Rubber was now a fixture on the axle box with no movement at all keeps the wheel in place

4. With all these added benefits HPI has made wheel maintenance free with sealed bearing boxes and no grease is required.

5. This unit fits to existing cars with no alterations, free height, mounting centers etc.

6. The store stock will drop in components instead of having rubbers, clamps and cannon box wheels. The quarto has one complete unit.

GENERAL FACTS :

With load capacity on 2 bearings per 2 wheels  as per the Cannonbox wheels est. work life ± 3 months.

Quatro with 4 bearings to 5 TON per 2 wheels.
This improves safety, durability and cost saving, est. work life ± 18 -24 months.

The Quatro is a patented product of High Power innovations
Patent no : 2002 / 0961

THE QUATRO HAS PROVEN ITSELF WITH TIME:

Since the introduction of the Quatro wheels  we have seen this product out perform any other product on the market.  In the years that have gone past we have had Quatro’s being used for more than 6 years without it failing and only the wheel casting that were worn and needed replacement. All axle boxes still turning & moving freely.

Quatro made on the 16-01-2003 only came back for repair in August 2009

In January 2010 we had 19 Quatro’s come in for repair on job number , HPI- 5578. All these quarto were from the  2005 December – 2006 March . All boxes were still turning , only the wheel were worn. We replaced  the bearing , seals & wheel castings and they were ready to be returned for  another few years to come.

19 Quatro’s HPI-5578

For References , please contact  :

Mr. W. Breytenbach                                        MR. B BARNARD
Beatrix / Oryx MINE                                       KLOOF MAIN SHAFT
082 371 9635                                                     084 602 5022

This CMH Box was scraped due to bearing failure with resulted in the shaft ripping up the box end, center  plates & the shaft it self rendering it useless.

A closer look at the damage of the bearing failure.

This is a re-conditioned CMH Wheel assembly with no standard sealing arrangement except for the bearing seal itself be it 6314 2RS.

No standard sealing arrangement as can be seen on this photograph. Leaving a clear space between the wheel and box end.

HPI Quatro Rolvec – The CMH Solution

Assembly

Here is the new Quatro Rolvec box being assembled with tapered roller bearings.

The Bearing assembly has now been fitted with a specially designed bearing spacer to give the bearing maximum life & durability.

Now the the spacer has been fitted into place with the second tapered bearing , leaving only space for the last uni seal.